Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM › from 2017.06
RM2170E _58 Vehicle Interior _057042 HEATING / AIR CONDITIONING _0278125 AIR CONDITIONING SYSTEM C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  B1412/12  Ambient Temperature Sensor Circuit  


DESCRIPTION

The ambient temperature sensor (thermistor assembly) is installed in front of the condenser to detect the ambient temperature. Its signal is used for air conditioning control in AUTO mode. This sensor is connected to the air conditioning amplifier assembly and detects fluctuations in the ambient temperature. This data is used for controlling the cabin temperature. The sensor sends a signal to the air conditioning amplifier assembly. The resistance of the ambient temperature sensor (thermistor assembly) changes in accordance with the ambient temperature. As the temperature decreases, the resistance increases. As the temperature increases, the resistance decreases.

The air conditioning amplifier assembly applies a voltage (5 V) the ambient temperature sensor (thermistor assembly) and reads voltage changes due to changes in the resistance of the ambient temperature sensor (thermistor assembly).

DTC No. DTC Detection Condition Trouble Area
B1412/12 Open or short in ambient temperature sensor (thermistor assembly) circuit
·

Ambient temperature sensor (thermistor assembly)

·

Harness or connector between ambient temperature sensor (thermistor assembly) and air conditioning amplifier assembly

·

Air conditioning amplifier assembly



WIRING DIAGRAM

E236722E47
2.146,0.458 2.24,0.635 0.094,0.177 10 false 1 2.146,1.406 2.24,1.583 0.094,0.177 10 false 2 1.958,0.458 2.073,0.635 0.115,0.177 10 false + 1.99,1.406 2.073,1.583 0.083,0.177 10 false - 5.115,0.458 5.292,0.635 0.177,0.177 10 false 5 5.115,1.417 5.292,1.594 0.177,0.177 10 false 13 5.417,0.552 5.74,0.729 0.323,0.177 10 false TAM 5.417,1.5 5.76,1.677 0.344,0.177 10 false SG-2 0.833,1.792 1.156,1.969 0.323,0.177 10 false A79 0.833,1.948 2.729,2.281 1.896,0.333 10 false Ambient Temperature Sensor (Thermistor Assembly) 5.063,1.875 5.344,2.052 0.281,0.177 10 false G34 5.063,2.031 6.74,2.344 1.677,0.313 10 false Air Conditioning Amplifier Assembly

PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body / Air Conditioner / Data List.


e.

Check the value(s) by referring to the table below.


Air Conditioner
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Ambient Temp Sensor Ambient temperature sensor (thermistor assembly) /
Min: -23.30°C (-9.94°F)
Max: 65.95°C (150.71°F)
Actual ambient temperature displayed -

OK:

The display is as specified in the normal condition column.


Result:
Result Proceed to
OK (When troubleshooting according to Problem Symptoms Table) A
OK (When troubleshooting according to the DTC) B
NG C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

C

2.INSPECT AMBIENT TEMPERATURE SENSOR (THERMISTOR ASSEMBLY)
2.INSPECT AMBIENT TEMPERATURE SENSOR (THERMISTOR ASSEMBLY)
a.

Remove the ambient temperature sensor (thermistor assembly).

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AMBIENT TEMPERATURE SENSOR>REMOVAL


b.

Inspect the ambient temperature sensor (thermistor assembly).

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AMBIENT TEMPERATURE SENSOR>INSPECTION



OK

3.CHECK HARNESS AND CONNECTOR (AMBIENT TEMPERATURE SENSOR (THERMISTOR ASSEMBLY) - AIR CONDITIONING AMPLIFIER ASSEMBLY)

NG

REPLACE AMBIENT TEMPERATURE SENSOR (THERMISTOR ASSEMBLY)

3.CHECK HARNESS AND CONNECTOR (AMBIENT TEMPERATURE SENSOR (THERMISTOR ASSEMBLY) - AIR CONDITIONING AMPLIFIER ASSEMBLY)
a.

Disconnect the G34 air conditioning amplifier assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A79-2 (-) - G34-5 (TAM) Always Below 1 Ω
A79-1 (+) - G34-13 (SG-2) Always Below 1 Ω
A79-2 (-) or G34-5 (TAM) - Body ground Always 10 kΩ or higher
A79-1 (+) or G34-13 (SG-2) - Body ground Always 10 kΩ or higher




OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR