Home › Drivetrain › P510 (HYBRID TRANSMISSION / TRANSAXLE) › TRANSMISSION CONTROL CABLE › from 2017.06
RM2170E _52 Drivetrain _057013 P510 HYBRID TRANSMISSION / TRANSAXLE _0277994 TRANSMISSION CONTROL CABLE A

P510 HYBRID TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  REMOVAL  


PROCEDURE

Hide 1.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 58041A 3.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR SUB-ASSEMBLY

a.
C251099

Remove the nut and 2 bolts and front No. 1 floor heat insulator sub-assembly.


Hide 33820B 4.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C249908

Disconnect the cable end from the shift lever assembly.


c.
C249910E01
0.609,0.182 0.791,0.349 0.182,0.167 10 *a 1.334,0.034 1.517,0.201 0.182,0.167 10 *b 0.268,1.401 0.450,1.568 0.182,0.167 10 *1 0.456,1.496 0.562,1.496 0.562,1.496 0.879,0.775 false

Rotate the nut approximately 180° in the direction shown in the illustration, and while holding the nut, disconnect the transmission control cable assembly from the shift lever plate.

Text in Illustration
*1 Nut
*a Rotate Approximately 180°
*b Disconnect

NOTICE:

Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.



d.
C249710E02
1.156,1.51 1.385,1.51 true 2.594,1.333 2.833,1.333 true 1.427,1.438 1.625,1.625 0.198,0.188 10 true *1 2.865,1.26 3.063,1.458 0.198,0.198 10 true *2

Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.

Text in Illustration
*1 Transmission Control Cable Clamp
*2 Transmission Control Cable Support


e.

Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.


f.

Separate the transmission control cable assembly from the transmission control cable clamp and transmission control cable support.


g.
C261399

Remove the 3 nuts and then remove the transmission control cable assembly from the vehicle exterior.


Hide 33829K 5.REMOVE NO. 2 TRANSMISSION CONTROL CABLE CLAMP

HINT:

Perform this procedure only when replacement of the No. 2 transmission control cable clamp is necessary.


a.
C251101

Remove the nut and No. 2 transmission control cable clamp from the body.