The power steering ECU assembly supplies a voltage of 5 V to the torque sensor (electric power steering column sub-assembly) and monitors the voltage value of the Hall IC inside the torque sensor (electric power steering column sub-assembly) which changes in response to changes in the magnetic flux density (steering torque) detected by the Hall IC, and calculates the assist torque.
While DTC C1511/11 is detected, power assist is stopped due to fail-safe operation.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1511/11 | Diagnosis Condition: IG ON
Malfunction Status: TRQ1 voltage is less than 0.25 V or more than 4.6 V |
·
Torque sensor (Electric power steering column sub-assembly) ·
Power steering ECU assembly |
If the electric power steering column sub-assembly has been replaced, perform torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
If the power steering ECU assembly has been replaced, perform assist map writing and torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
| *a | Component without harness connected
(Torque Sensor (Electric Power Steering Column Sub-assembly)) |
Disconnect the power steering ECU assembly connector.
Connect 3 new 1.5 V batteries in series to prepare a 4.5 V power supply.
Check that the voltage of the prepared power supply is 4.5 V.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| z7-1(TRQ1) - z7-2(TRQG) | 1.
Connect the 4.5 V positive (+) terminal to z7-8 (TRQV) and 4.5 V negative (-) terminal to z7-2 (TRQG) 2.
Steering wheel not being turned (without load) |
2.07 to 2.43 V |
1.
Connect the 4.5 V positive (+) terminal to z7-8 (TRQV) and 4.5 V negative (-) terminal to z7-2 (TRQG) 2.
Steering wheel being turned to right with vehicle stopped |
2.25 to 3.42 V | |
1.
Connect the 4.5 V positive (+) terminal to z7-8 (TRQV) and 4.5 V negative (-) terminal to z7-2 (TRQG) 2.
Steering wheel being turned to left with vehicle stopped |
1.08 to 2.25 V |
To avoid damaging the torque sensor (electric power steering column assembly), do not apply a voltage of more than 5 V.
The voltage values specified above are applicable when using an applied voltage of 4.5 V, and vary depending on the applied voltage (When compared to values for an applied voltage of 5 V, these values differ by a factor of 0.9).
When using an applied voltage of 5 V, the specified values are as follows.
| Condition | Specified Condition |
|---|---|
| Steering wheel not being turned (without load) | 2.3 to 2.7 V |
| Steering wheel being turned to right with vehicle stopped | 2.5 to 3.8 V |
| Steering wheel being turned to left with vehicle stopped | 1.2 to 2.5 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG