Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › WHEEL OPENING MOULDING(for Rear Side) › from 2018.08
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0364199 WHEEL OPENING MOULDING(for Rear Side) A

EXTERIOR PANELS / TRIM  WHEEL OPENING MOULDING(for Rear Side)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 75606B 2.REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY

a.

Remove the screw.

B481726C01
0,0 0,0 false
V100135

Screw
V100136

Clip



b.

Using a clip remover, remove the clip.


c.
B481727C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the quarter outside moulding sub-assembly.


d.
B481760

Disengage the 4 claws by pushing the area indicated by the arrow in the illustration with a finger.

NOTICE:

To avoid damaging the claws, do not forcibly pull the quarter outside moulding sub-assembly.



e.
B481728

Disengage the 5 clips to remove the quarter outside moulding sub-assembly.