Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2018.08
RM2170E _53 Suspension _057019 TIRE PRESSURE MONITORING _0278018 TIRE PRESSURE WARNING SYSTEM D

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  DIAGNOSIS SYSTEM  


CHECK WARNING LIGHT


NOTICE:
·

When there is a problem with the tire pressure warning system, the tire pressure warning light blinks at 0.5 second intervals, and illuminates after 1 minute.

·

When the malfunction has been corrected, the tire pressure warning light goes off.

·

When the tire pressure warning light illuminates, immediately check the tire pressure of the tires and adjust them to the specified value.

·

After the power switch is turned on (IG), the tire pressure warning light illuminates for 3 seconds and then goes off. If the warning light does not illuminate for 3 seconds, proceed to the troubleshooting for the tire pressure warning light circuit (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>Tire Pressure Warning Light Circuit).



a.
C213286E12
0.616,0.112 0.987,0.358 0.371,0.246 10 *1

Turn the power switch on (IG).

Text in Illustration
*1 Tire Pressure Warning Light


b.

Check that the tire pressure warning light illuminates for 3 seconds.



WHAT TO CONSIDER WHEN TIRE PRESSURE WARNING LIGHT ILLUMINATES


a.

When the tire pressure warning light does not go off, or when it illuminates during driving, check the tire pressure. If the tire pressure warning light illuminates within several hours after adjusting the tire pressure, a tire may have a slow air leak.


b.

The system is disabled under the following conditions (when the condition returns to normal, the system will work properly).

i.

When all of the tire and wheel assemblies that have tire pressure warning valve and transmitters registered with the tire pressure warning ECU and receiver have not been installed.


ii.

When all of the transmitter ID codes are not registered with the tire pressure warning ECU and receiver.


iii.

When the tire pressure warning valve and transmitter battery is depleted (Battery life is 10 years).



c.

The system may become disabled under the following conditions (when the condition returns to normal, the system will work properly).

i.

When electric devices or facilities using similar radio frequencies are nearby.


ii.

When a wireless device or other equipment operating at a similar frequency is in use in the vehicle.


iii.

When a window tint that affects radio wave signals is installed.


iv.

When there is a lot of snow or ice on the vehicle, in particular, around the wheels or wheel housing.


v.

When non-genuine wheels are used.


vi.

When tire chains are used.


vii.

When aftermarket tire repair sealant is used.

CAUTION:

After use of tire repair sealant, replacement of the tire pressure warning valve and transmitter is required to ensure normal system operation. (Normal system operation cannot be ensured by only repairing or replacing the tire.)





TIRE PRESSURE WARNING LIGHT AND INDICATOR CHART


HINT:

The table below indicates the state of the tire pressure warning light after the power switch is turned on (IG).

Immediately after turning the power switch on (IG) Always
Warning light output pattern
Illuminates for 3 sec. Goes off Illuminates Blinks*1 Blinks*2 Blinks*3 Blinks*4 (w/o Occupant Classification System) Blinks*5 Outputs DTC (w/o Occupant Classification System)
Normal ○ ○ - - - - - - -
Low tire pressure ○ - ○ - - - - - -
System failure ○ - - ○ - - - - -
Test mode (signal check mode) ○ - - - ○ - - - -
Initialization ○ - - - - ○ - - -
ECU connector poorly connected - - - - - - - ○ -
TC grounded (DTCs are output) (w/o Occupant Classification System) ○ - - - - - - - ○
TC grounded (DTCs are not output) (w/o Occupant Classification System) ○ - - - - - ○ - -


E133091E11
1.011,1.377 1.518,1.531 0.507,0.154 10 *c 1.145,0.312 1.364,0.466 0.220,0.154 10 *c 0.204,0.683 0.453,0.822 0.250,0.139 10 *a 0.204,1.001 0.509,1.140 0.305,0.139 10 *b 1.523,1.783 1.757,1.922 0.235,0.139 10 *d

*1: Blinks at 0.5 second intervals, and stays illuminated after 1 minute.

Text in Illustration
*a ON
*b OFF
*c 0.5 sec.
*d 1 minute

C350385E03
0.688,0.479 1.521,0.708 0.833,0.229 10 false *c 0.073,0.813 0.906,1.042 0.833,0.229 10 false *a 0.083,1.104 0.917,1.333 0.833,0.229 10 false *b 0.396,1.51 1.229,1.74 0.833,0.229 10 false *c

*2: Blinks at 0.125 second intervals.

Text in Illustration
*a ON
*b OFF
*c 0.125 sec.

C110636E18
1.003,0.423 1.407,0.587 0.404,0.164 10 *c 0.745,1.471 1.150,1.635 0.404,0.164 10 *c 0.225,0.814 0.463,0.978 0.238,0.164 10 *a 0.225,1.11 0.525,1.274 0.300,0.164 10 *b

*3: Blinks 3 times at 1 second intervals.

Text in Illustration
*a ON
*b OFF
*c 1 sec.

C145821E11
1.356,0.494 1.939,0.636 0.583,0.142 10 *c 0.256,0.846 0.484,0.988 0.229,0.142 10 *a 0.256,1.184 0.554,1.326 0.298,0.142 10 *b 1.226,1.541 1.809,1.683 0.583,0.142 10 *c

*4: Blinks at 0.25 second intervals.

Text in Illustration
*a ON
*b OFF
*c 0.25 sec.

C264349E08
2.114,1.492 2.621,1.646 0.507,0.154 10 *c 1.703,0.221 1.923,0.375 0.220,0.154 10 *c 0.13,0.693 0.380,0.832 0.250,0.139 10 *a 0.129,1.003 0.434,1.141 0.305,0.139 10 *b 1.964,1.864 2.198,2.002 0.235,0.139 10 *d 0.852,0.231 1.102,0.369 0.250,0.139 10 *e

*5: Goes off for 10 seconds to check the connection of the ECU connector, and then blinks at 0.5 second intervals, and stays illuminated after 1 minute.

Text in Illustration
*a ON
*b OFF
*c 0.5 sec.
*d 1 minute
*e 10 sec.



NORMAL MODE DTC


a.

DTCs are stored in the tire pressure warning ECU and receiver and are output by blinking the tire pressure warning light*1 or by using the GTS (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DTC CHECK / CLEAR).

*1: Only for vehicles without occupant classification system



TEST MODE (SIGNAL CHECK MODE) DTC


a.

By switching from normal mode into test mode (signal check mode), you can inspect the tire pressure warning ECU and receiver, each tire pressure warning valve and transmitter and tire pressure warning reset switch (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>TEST MODE PROCEDURE).