CHECK DTC (USING GTS)
Turn the power switch off (lock).
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Read the DTCs following the display on the GTS. Enter the following menus: Chassis / EMPS / DTC.
Refer to the Diagnostic Trouble Code Chart for DTC information (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
CHECK DTC (USING SST CHECK WIRE) (w/o Occupant Classification System)
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
| *1 | DLC3 |
Turn the power switch on (IG).
Read and write down any DTCs indicated by the EPS warning light on the combination meter assembly. Refer to the chart on the left for examples of a normal code and DTCs 21 and 22.
If two or more malfunctions are detected simultaneously, DTCs will be displayed in ascending numerical order.
Refer to the Diagnostic Trouble Code Chart for DTC information (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
| *1 | Normal code |
| *2 | Codes 21 and 22 |
| *a | ON |
| *b | OFF |
| *c | Seconds |
| *d | Code 21 |
| *e | Code 22 |
CLEAR DTC (USING GTS)
Turn the power switch off (lock).
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Clear the DTCs following the display on the GTS. Enter the following menus: Chassis / EMPS / DTC / Clear.
According to the display on the GTS, select the trouble code data display with the clear button.
Turn the power switch off (lock).
Disconnect the GTS from the DLC3.
CLEAR DTC (USING SST CHECK WIRE) (w/o Occupant Classification System)
Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3, and also terminals 13 (TC) and 4 (CG) of the DLC3.
Turn the power switch on (IG).
Disconnect and reconnect terminal 13 (TC) of the DLC3 4 times or more within 8 seconds.
Check that the EPS warning light blinks a code to indicate normality.
Turn the power switch off (lock).
Remove SST from the DLC3.
| *1 | DLC3 |