The headlight leveling ECU assembly receives signals indicating the height of the vehicle from the rear height control sensor sub-assembly.
| DTC No. | Detection Item | DTC Detecting Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| B241A | Rear Height Control Sensor | ·
Malfunction in rear height control sensor sub-assembly ·
Open or short in rear height control sensor sub-assembly circuit |
·
Rear height control sensor sub-assembly ·
Harness or connector ·
Headlight leveling ECU assembly |
Headlight leveling ECU assembly |
If the headlight leveling ECU assembly has been replaced, it is necessary to initialize the headlight leveling ECU assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION
If any of the following are performed, it is necessary to initialize the headlight leveling ECU assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION
Replacement of the rear height control sensor sub-assembly
Removal/installation of the rear height control sensor sub-assembly
Work that changes the vehicle height such as replacement of suspension components
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
Check for DTCs.
DTC B241A is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Rr Height Sens Signal Val | Rear height control sensor sub-assembly signal value | 0.00 to 5.00 V | 0.50 to 4.50 V | Value changes according to vehicle height |
Normal condition listed above is displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear height control sensor sub-assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>HEIGHT CONTROL SENSOR>REMOVAL
Inspect the rear height control sensor sub-assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>HEIGHT CONTROL SENSOR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the A34 headlight leveling ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R1-2 (SHRR) - A34-19 (SHRL) | Always | Below 1 Ω |
| R1-2 (SHRR) or A34-19 (SHRL) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG