1.INSPECT BRAKE LINE PIPES AND HOSES
Work in a well-lighted area. Turn the front wheels fully to the right or left before beginning the inspection.
Using a mirror, check the entire circumference and length of the brake lines and hoses for:
Damage
Wear
Deformation
Cracks
Kinks
Corrosion
Leaks
Twists
Check all clamps for tightness and check the connections for leakage.
Check that the hoses and lines are not near sharp edges, moving parts or the exhaust system.
Check that the lines are installed properly and pass through the center of the grommets.
2.INSPECT BRAKE PEDAL
Check the brake pedal (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for LHD)>ADJUSTMENT for LHD, Brake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for RHD)>ADJUSTMENT for RHD).
3.INSPECT PARKING BRAKE
Check the parking brake shoe clearance and parking brake pedal travel (See page Brake>PARKING BRAKE>PARKING BRAKE SYSTEM>ADJUSTMENT).
Check the parking brake cables to ensure that they are not deformed or binding.
4.INSPECT BRAKE LININGS AND DRUMS
Check the parking brake linings and drums (See page Brake>PARKING BRAKE>PARKING BRAKE ASSEMBLY>INSPECTION).
5.INSPECT FRONT BRAKE
Check the front brake pads and discs (See page Brake>BRAKE (FRONT)>FRONT BRAKE>INSPECTION).
6.INSPECT REAR BRAKE
Check the rear brake pads and discs (See page Brake>BRAKE (REAR)>REAR BRAKE>INSPECTION).
7.INSPECT OR CHANGE BRAKE FLUID
Inspect or change the brake fluid (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID>REPLACEMENT).
SAE J1703 or FMVSS No. 116 DOT3