89422
1.INSTALL ENGINE COOLANT TEMPERATURE SENSOR
Install the engine coolant temperature sensor with a new gasket.
| *a | Fulcrum Length
25 mm |
| *b | Fulcrum Length
180 mm |
The "with SST" torque value is effective when using SST with a fulcrum length of 25 mm (0.984 in.) and a torque wrench with a fulcrum length of 180 mm (7.09 in.) (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
The "with SST" torque value is effective when SST is parallel to the torque wrench.
Connect the engine coolant temperature sensor connector.
G92A0A
2.INSTALL INVERTER RESERVE TANK ASSEMBLY
23250
3.INSTALL FUEL INJECTOR ASSEMBLY