23250
1.INSTALL FUEL INJECTOR ASSEMBLY
Install a new insulator and O-ring to each fuel injector assembly.
| *1 | O-ring |
| *2 | Insulator |
Apply a light coat of gasoline or spindle oil to the contact surfaces of the new O-ring on each fuel injector assembly.
While turning the fuel injector assembly left and right, install it onto the fuel delivery pipe sub-assembly.
Do not damage the fuel injector assembly or O-ring.
Do not twist the O-ring.
After installing each fuel injector, check that it turns smoothly. If not, replace the O-ring with a new one.
23807V
2.INSTALL NO. 1 DELIVERY PIPE SPACER
Install the 2 No. 1 delivery pipe spacers onto the cylinder head.
| *a | Delivery Pipe Side |
| *b | Cylinder Head Side |
Install the No. 1 delivery pipe spacers in the correct direction.
23807
3.INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY
Install the fuel delivery pipe sub-assembly with the 4 fuel injector assemblies and install the 2 bolts.
Do not drop the fuel injectors when installing the fuel delivery pipe sub-assembly.
Check that the fuel injector assemblies rotate smoothly after installing the fuel delivery pipe sub-assembly.
Install the bolt to secure the fuel delivery pipe sub-assembly.
23901
4.CONNECT FUEL TUBE SUB-ASSEMBLY
Push the tube connector into the pipe until the tube connector makes a "click" sound.
Before connecting the connector and fuel pipe, check that there is no damage or foreign matter on the connecting part of the fuel pipe.
After connecting the fuel tube connector and pipe, check that they are securely connected by pulling on them.
Engage the lock claw to install the No. 1 fuel pipe clamp.
82121
5.CONNECT ENGINE WIRE
Install the bolt.
Connect the 4 fuel injector connectors.
Connect the 4 connectors.
Attach the 2 clamps to connect the engine wire.
25601L
6.INSTALL EGR WITH COOLER PIPE SUB-ASSEMBLY
7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
8.INSPECT FOR FUEL LEAK
64995
9.INSTALL DECK FLOOR BOX RH
64993
10.INSTALL REAR DECK FLOOR BOX
58412A
11.INSTALL NO. 2 DECK BOARD
58411A
12.INSTALL NO. 1 DECK BOARD
58410B
13.INSTALL DECK BOARD ASSEMBLY