Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID BATTERY SYSTEM › from 2016.05
RM2070E _51 Engine / Hybrid System _061906 HYBRID / BATTERY CONTROL _0301574 HYBRID BATTERY SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID BATTERY SYSTEM  P3011-123  Battery Block 1 Becomes Weak  P3012-123  Battery Block 2 Becomes Weak  P3013-123  Battery Block 3 Becomes Weak  P3014-123  Battery Block 4 Becomes Weak  P3015-123  Battery Block 5 Becomes Weak  P3016-123  Battery Block 6 Becomes Weak  P3017-123  Battery Block 7 Becomes Weak  P3018-123  Battery Block 8 Becomes Weak  


DESCRIPTION

Refer to the Description for DTC P0A80-123 (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>P0A80-123).


DTC No. INF Code DTC Detection Condition Trouble Area
P3011
P3012
P3013
P3014
P3015
P3016
P3017
P3018
123 Presence of a malfunctioning block is determined based on each battery block voltage (1 trip detection).
·

HV battery

·

Battery smart unit



HINT:
·

P3011-123 to P3018-123 will not be set unless the vehicle is driven for approximately 10 minutes after clearing the DTCs.

·

In order to ensure HV battery performance, appropriate cooling performance must be maintained. Perform the following items as necessary:

-

Make sure the air intake port is not blocked.

-

Make sure there are no gaps between the connecting parts of the ducts.




CAUTION / NOTICE / HINT

CAUTION:
·

When disposing of an HV battery, make sure to return it through an authorized collection agent who is capable of handling it safely. If the HV battery is returned via the manufacturer specified route, it will be returned properly and in a safe manner by an authorized collection agent.

·

Before returning the HV battery, make sure to perform a recovery inspection (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HV BATTERY>RECOVERY INSPECTION)

·

Make a note of the output DTCs as some of them may be necessary for recovery inspection of the HV battery.



PROCEDURE

1.CHECK DTC OUTPUT (HYBRID CONTROL)

A

2.READ VALUE USING GTS (VB1 - VB8)

B

2.READ VALUE USING GTS (VB1 - VB8)

A

B

3.CHECK BATTERY SMART UNIT
3.CHECK BATTERY SMART UNIT

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>P0A7F-123

Result:
Result Proceed to
All measured values were within specified range. A
Other than above. B



A

B

4.REPLACE BATTERY SMART UNIT