Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › WATER PUMP WITH MOTOR
RM2070E _51 Engine / Hybrid System _061906 HYBRID / BATTERY CONTROL _0301579 WATER PUMP WITH MOTOR A

HYBRID / BATTERY CONTROL  WATER PUMP WITH MOTOR  INSTALLATION  


PROCEDURE

Hide G9040 1.INSTALL INVERTER WATER PUMP ASSEMBLY

a.

Install the inverter water pump assembly and water pump bracket with the 3 bolts.

Torque:
6.1 N*m (62 kgf*cm, 54 in.*lbf)

NOTICE:

Do not hold the inverter water pump assembly by the connector terminals when removing or installing it.



b.
A248068E03
1.01,0.604 1.323,0.354 1.323,0.354 1.385,0.354 false 1.917,0.594 2.198,0.313 2.198,0.313 2.26,0.313 false 1.24,3.781 1.313,3.854 1.313,3.854 1.469,3.854 false 2.302,3.896 2.385,3.604 2.385,3.604 2.552,3.604 false 0.25,0.51 0.438,0.719 0.188,0.208 10 false *a 1.188,4.229 1.375,4.385 0.188,0.156 10 false *a 1.406,0.271 1.594,0.427 0.188,0.156 10 false *b 2.271,0.219 2.458,0.375 0.188,0.156 10 false *b 1.49,3.76 1.729,3.958 0.24,0.198 10 false *c 2.563,3.521 2.75,3.677 0.188,0.156 10 false *c

Connect the 2 water hoses and connector.

Text in Illustration
*a Front Side
*b Alignment Mark (Green)
*c Alignment Mark (Pink)

NOTICE:
·

Make sure that the clip is positioned as shown in the illustration.

·

Make sure to align the alignment marks of the hoses with the ribs of the inverter water pump assembly.

·

Do not remove the pieces of cloth from the pipes and disconnected hoses until installation to prevent foreign matter from entering the inverter water pump and cooling system.




Hide G9200 4.INSTALL INVERTER WITH CONVERTER ASSEMBLY

Hide 51441 7.INSTALL NO. 1 ENGINE UNDER COVER