Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY BLOWER › from 2016.05
RM2070E _51 Engine / Hybrid System _061906 HYBRID / BATTERY CONTROL _0301587 BATTERY BLOWER A

HYBRID / BATTERY CONTROL  BATTERY BLOWER  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY RH

Hide 67913 2.REMOVE FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).


Hide 62111C 3.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).


Hide 67917A 4.REMOVE REAR DOOR SCUFF PLATE RH

HINT:

Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).


Hide 73233 5.REMOVE LAP BELT OUTER ANCHOR COVER (for RH Side)

Hide 73210 6.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

Hide 62311B 7.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side (See page Vehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>REMOVAL).


Hide 62331A 8.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side (See page Vehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>REMOVAL).


Hide 62413A 9.REMOVE CENTER PILLAR LOWER GARNISH RH

HINT:

Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).


Hide 77306 10.REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY (for RHD)

Hide G9230 11.REMOVE BATTERY COOLING BLOWER ASSEMBLY

NOTICE:
·

Be sure not to touch the fan part of the battery cooling blower assembly.

·

Do not lift the battery cooling blower assembly using the wire harness.



a.
A251510

Disconnect the 2 clips and remove the No.1 rear heater register bezel.


b.

Turn over the front floor carpet.


c.
A251475

Remove the 3 clips and No. 1 hybrid battery intake duct.


d.
A251476

Disconnect the connector.


e.

Remove the 2 bolts.


f.
A251477

Remove the 3 nuts and battery cooling blower assembly from the battery cooling blower bracket.


Hide G92D2 12.REMOVE NO. 2 HYBRID BATTERY INTAKE DUCT

HINT:

Perform this procedure only when replacement of the No. 2 hybrid battery intake duct is necessary.



b.
A251478

Remove the 2 clips and No. 2 hybrid battery intake duct.