Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID VEHICLE CONTROL ECU › from 2016.05
RM2070E _51 Engine / Hybrid System _061906 HYBRID / BATTERY CONTROL _0301592 HYBRID VEHICLE CONTROL ECU A

HYBRID / BATTERY CONTROL  HYBRID VEHICLE CONTROL ECU  INSTALLATION  


PROCEDURE

Hide 89981C 1.INSTALL HYBRID VEHICLE CONTROL ECU (for LHD)

a.
A379151

Engage the 2 claws to install the hybrid vehicle control ECU as shown in the illustration.

NOTICE:

Make sure that the hybrid vehicle control ECU is securely installed.



Hide 89981C 2.INSTALL HYBRID VEHICLE CONTROL ECU (for RHD)

a.
E190822

Engage the 2 claws to install the hybrid vehicle control ECU as shown in the illustration.

NOTICE:

Make sure that the hybrid vehicle control ECU is securely installed.



Hide 82877 3.INSTALL ECU INTEGRATION BOX RH (for LHD)

a.

Install the ECU integration box RH with the bolt and 2 nuts.


b.

Engage the 3 clamps.


c.

Connect each connector.


Hide 82878 4.INSTALL ECU INTEGRATION BOX LH (for RHD)

a.

Install the ECU integration box LH with the bolt and nut.


b.

Engage the clamp.


c.

Connect each connector.


Hide 55550 5.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 55607 6.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 13. PERFORM INITIALIZATION