Home › Engine / Hybrid System › 2ZR-FXE (FUEL) › FUEL TANK › 2012.03–2013.08
RM2070E _51 Engine / Hybrid System _061908 2ZR-FXE FUEL _0301604 FUEL TANK A

2ZR-FXE FUEL  FUEL TANK  REMOVAL  


PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 2.DRAIN FUEL

Hide 17410 3.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 57627A 4.REMOVE REAR FLOOR SIDE MEMBER COVER RH

Hide 53605F 5.REMOVE REAR SUSPENSION BRACE SUB-ASSEMBLY

Hide 77641A 6.REMOVE NO. 1 FUEL TANK PROTECTOR

a.
A251215

Remove the 4 clips as shown in the illustration, and remove the No. 1 fuel tank protector.


Hide 7.DISCONNECT FUEL TANK BREATHER TUBE

a.
A251216E01
0.628,0.723 0.810,0.894 0.181,0.171 10 *1 1.788,0.793 1.970,0.963 0.181,0.171 10 *2 1.799,0.155 1.981,0.325 0.181,0.171 10 *3 1.294,0.635 1.646,0.26 1.646,0.26 1.749,0.26 false 1.539,0.895 1.754,0.895 false 1.261,1.102 0.972,0.812 0.972,0.812 0.83,0.812 false

Loosen the clamp, then disconnect the fuel tank breather tube.

Text in Illustration
*1 Fuel Tank Breather Tube
*2 Charcoal Canister Outlet Hose
*3 Breather Tube Clamp


Hide 77754B 8.DISCONNECT CHARCOAL CANISTER OUTLET HOSE

a.

Disconnect the charcoal canister outlet hose. and fuel tank breather tube from the No. 1 fuel tube clamp.


b.

Disconnect the charcoal canister outlet hose and fuel tank breather tube from the breather tube clamp.


Hide 77213E 9.DISCONNECT FUEL TANK TO FILLER PIPE HOSE

a.
A251217

Loosen the clamp, and then disconnect the fuel tank to filler pipe hose from the fuel filler pipe.


Hide 77026A 10.DISCONNECT NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY

a.
A251218

Loosen the clip, then disconnect the No. 1 fuel evaporation tube sub-assembly.

NOTICE:
·

Remove any dirt or foreign matter on the No. 1 fuel evaporation tube sub-assembly before performing this work.

·

Protect the disconnected part by covering it with a plastic bag after disconnecting the No. 1 fuel evaporation tube sub-assembly.




Hide 77209F 11.REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY

a.

Pull the tabs of the retainer to disengage the lock claws and pull out the fuel tank main tube sub-assembly.

A398189E01
1.469,3.115 1.635,3.115 1.635,3.115 1.76,2.948 false 4.396,1.854 4.563,1.854 4.563,1.854 4.76,2.052 false 5.583,2.302 5.906,1.948 5.906,1.948 6.083,1.948 false 5.781,2.49 5.927,2.354 5.927,2.354 6.073,2.354 false 5.74,2.708 6.094,2.708 false 5.281,2.865 5.281,2.698 false 4.948,2.865 5.406,2.865 5.406,2.865 5.406,2.708 false 1.271,3.021 1.583,3.219 0.313,0.198 10 false *1 4.177,1.76 4.49,1.958 0.313,0.198 10 false *3 6.135,1.854 6.448,2.052 0.313,0.198 10 false *2 6.115,2.271 6.427,2.469 0.313,0.198 10 false *4 6.135,2.615 6.448,2.813 0.313,0.198 10 false *1 4.76,2.771 5.073,2.969 0.313,0.198 10 false *5

Text in Illustration
*1 Retainer
*2 Fuel Tube Connector
*3 Fuel Tank Main Tube
*4 Fuel Pipe
*5 O-ring
V100136

Pull

NOTICE:
·

Check that there are no scratches or foreign matter around the connected part of the fuel tube connector and fuel pipe before performing this work.

·

Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the fuel tube connector has O-rings that seal the fuel pipe.

·

Only disconnect the fuel tube connector by hand.

·

Do not forcibly bend, twist or turn the fuel tank main tube.

·

Protect the disconnected part by covering it with a plastic bag after disconnecting the fuel tube connector.

·

If the fuel tube connector and fuel pipe are stuck, push and pull to release them.




Hide 77100 12.REMOVE FUEL TANK ASSEMBLY

a.
A251220

Support the fuel tank using an engine lifter.


b.
A251221

Remove the 4 set bolts of the 2 fuel tank bands.


c.

Lower the engine lifter to remove the fuel tank.

NOTICE:
·

Slowly operate the engine lifter to lower the fuel tank.

·

Do not drop the fuel tank.

·

When removing the fuel tank, tilt it slightly to prevent it from interfering with the suspension arm or other surrounding parts.




Hide 77651A 13.REMOVE NO. 1 FUEL TANK CUSHION

a.
A251222E02
1.208,0.167 1.208,0.115 1.208,0.115 2.719,0.115 false 2.344,0.167 2.344,0.115 false 0.875,1.073 0.875,1.573 0.875,1.573 2.938,1.573 false 1.323,0.75 1.323,1.573 false 2.135,0.583 2.135,1.573 false 2.604,1.052 2.604,1.573 false 2.958,1.469 3.115,1.625 0.156,0.156 10 false *1 2.75,0.031 2.906,0.188 0.156,0.156 10 false *2

Remove the 4 No. 1 fuel tank cushions.

Text in Illustration
*1 No. 1 Fuel Tank Cushion
*2 No. 2 Fuel Tank Cushion


Hide 77652A 14.REMOVE NO. 2 FUEL TANK CUSHION

a.

Remove the 2 No. 2 fuel tank cushions.


Hide 77209F 15.REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY

a.
A251223

Disengage the 2 clamps, and then remove the fuel tank main tube sub-assembly.


Hide 77026A 16.REMOVE NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY

a.
A251224

Disengage the 2 clamps, and then remove the No. 1 fuel evaporation tube sub-assembly.


Hide 77754B 17.REMOVE CHARCOAL CANISTER OUTLET HOSE

a.
A251226E02
2.698,0.469 2.885,0.656 2.885,0.656 3.052,0.656 false 1.948,0.479 1.656,0.219 1.656,0.219 1.521,0.219 false 1.583,0.677 1.333,0.427 1.333,0.427 1.229,0.427 false 3.063,0.563 3.25,0.74 0.188,0.177 10 false *1 1.313,0.135 1.5,0.313 0.188,0.177 10 false *2 1.031,0.344 1.219,0.521 0.188,0.177 10 false *3

Disconnect the No. 1 fuel tube clamp and remove the charcoal canister outlet hose.

Text in Illustration
*1 Charcoal Canister Outlet Hose
*2 Fuel Tank Breather Tube
*3 No. 1 Fuel Tube Clamp


b.

Remove the No. 1 fuel tube clamp from the fuel tank breather tube.


Hide 77213E 18.REMOVE FUEL TANK TO FILLER PIPE HOSE

a.
A251225

Loosen the hose clamp, and then remove the fuel tank to filler pipe hose.