1.DRAIN COOLANT (for Engine with Exhaust Heat Recirculation System)
17430
2.REMOVE TAIL EXHAUST PIPE ASSEMBLY
Remove the 2 bolts and 2 compression springs.
Remove the tail exhaust pipe assembly from the 2 exhaust pipe supports.
Remove the gasket from the front exhaust pipe assembly.
51442A
3.REMOVE FRONT NO. 3 ENGINE UNDER COVER
57533B
4.REMOVE FRONT CENTER FLOOR BRACE
Remove the 4 bolts and front center floor brace.
89465
5.REMOVE HEATED OXYGEN SENSOR
17410
6.REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/ Exhaust Heat Recirculation System)
Perform this procedure when the coolant is not hot.
Disconnect the 2 heater water hoses.
Remove the 2 bolts and 2 compression springs.
Remove the front exhaust pipe assembly from the 3 exhaust pipe supports.
Remove the gasket from the exhaust manifold.
17410
7.REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/o Exhaust Heat Recirculation System)
Remove the 2 bolts and 2 compression springs.
Remove the front exhaust pipe assembly from the 3 exhaust pipe supports.
Remove the gasket from the exhaust manifold.