17410
1.REMOVE FRONT EXHAUST PIPE ASSEMBLY
2.DRAIN COOLANT (for Engine)
17046
3.REMOVE EXHAUST PIPE GAS CONTROL ACTUATOR SUB-ASSEMBLY
Clean the area shaded in the illustration to prevent foreign matter from entering the cooling system.
| *1 | Flange of Exhaust Pipe Gas Control Actuator Sub-assembly |
|
Area to be Cleaned |
Remove the 5 bolts, exhaust pipe gas control actuator sub-assembly, exhaust by-pass pipe and No. 2 exhaust pipe heat insulator.
When removing the exhaust pipe gas control actuator sub-assembly, use caution because coolant may spill out from the exhaust heat recirculation system.
Do not apply any excessive force to the exhaust by-pass pipe when removing the exhaust pipe gas control actuator sub-assembly.
Remove the exhaust by-pass pipe from the exhaust pipe gas control actuator sub-assembly.