Home › Engine / Hybrid System › 2ZR-FXE (LUBRICATION) › OIL PUMP › 2012.03–2014.11
RM2070E _51 Engine / Hybrid System _061912 2ZR-FXE LUBRICATION _0301631 OIL PUMP A

2ZR-FXE LUBRICATION  OIL PUMP  REMOVAL  


PROCEDURE

Hide 13506 1.REMOVE CHAIN SUB-ASSEMBLY

Hide 13521 2.REMOVE CRANKSHAFT TIMING SPROCKET

a.
A218082

Remove the crankshaft timing sprocket.


Hide 13507 3.REMOVE NO. 2 CHAIN SUB-ASSEMBLY

a.

Temporarily tighten the crankshaft pulley with the crankshaft pulley bolt.


b.
A218083E02
0.267,1.138 0.575,1.289 0.307,0.150 10 SST 1.136,0.977 0.65,1.231 0.65,1.231 1.935,1.317 false

Using SST, remove the oil pump drive shaft sprocket nut while holding the crankshaft pulley.

SST
09213-58014  (91551-80840)
09330-00021  


c.

Remove SST, the crankshaft pulley and crankshaft pulley bolt.


d.
A218084

Remove the bolt, chain tensioner plate and chain damper spring.


e.
A218085E01
0.72,1.45 0.880,1.610 0.160,0.160 10 *1 1.241,2.435 1.435,2.595 0.194,0.160 10 *2 1.276,0.991 1.439,1.155 0.163,0.163 10 *3 1.71,2.724 1.583,2.518 1.583,2.518 1.445,2.518 false 1.235,1.828 1.051,1.53 1.051,1.53 0.92,1.53 false 1.488,1.064 1.609,1.064 1.609,1.064 1.821,1.486 false

Remove the oil pump drive gear, oil pump drive shaft gear and No. 2 chain sub-assembly.

Text in Illustration
*1 Oil Pump Drive Gear
*2 Oil Pump Drive Shaft Gear
*3 No. 2 Chain Sub-assembly


Hide 19315 4.REMOVE NO. 1 CRANKSHAFT POSITION SENSOR PLATE

Hide 12102A 7.REMOVE NO. 2 OIL PAN SUB-ASSEMBLY

a.
A150894

Remove the 10 bolts and 2 nuts.


b.
A120816

Insert the blade of an oil pan seal cutter between the crankcase and oil pan. Cut through the sealer and remove the oil pan.

NOTICE:

Be careful not to damage the contact surfaces of the crankcase and oil pan.



Hide 15100 8.REMOVE OIL PUMP ASSEMBLY

a.
A150895

Remove the 3 bolts and oil pump.