Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › 2016.05–2017.12
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301643 LANE DEPARTURE ALERT SYSTEM J

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  Indicator Circuit  


DESCRIPTION

When the lane departure warning camera detects a lane departure alert main switch signal, it sends the signal to the combination meter sub-assembly via CAN communication. Then the lane departure alert indicator turns on.

CAUTION / NOTICE / HINT

NOTICE:
·

When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera axis must be performed (See page Engine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT).

·

When replacing the lane departure warning camera, always replace it with a new one. If a lane departure warning camera which was installed to another vehicle is used, the information stored in the lane departure warning camera will not match the information from the vehicle. As a result, a DTC may be stored.



PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (METER DISPLAY 1)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform Active Test according to the display on GTS.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Meter Display 1 Multi-information display OFF or All Confirm that the vehicle is stopped with the power switch on (IG)



OK

2.READ VALUE USING GTS (LDA INDICATOR)

NG

2.READ VALUE USING GTS (LDA INDICATOR)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / Lane Departure Alert / Data List.


e.

Read the Data List according to the display on the GTS.

Lane Departure Alert
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
LDA Indicator Status of the lane departure alert indicator/Nothing or Green Nothing: Lane departure alert indicator is not illuminated
Green: Lane departure alert indicator is illuminated
-



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG