Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › 2014.11–2017.12
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301643 LANE DEPARTURE ALERT SYSTEM C

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  C1AA0  Front Camera Module Circuit  


DESCRIPTION

This DTC indicates an internal malfunction of the lane departure warning camera.

DTC No. DTC Detection Condition Trouble Area
C1AA0 While the power switch is on (IG), the lane departure warning camera detects an internal malfunction for about 5 seconds or more. Lane departure warning camera

CAUTION / NOTICE / HINT

NOTICE:
·

When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera axis must be performed (See page Engine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT).

·

When replacing the lane departure warning camera, always replace it with a new one. If a lane departure warning camera which was installed to another vehicle is used, the information stored in the lane departure warning camera will not match the information from the vehicle. As a result, a DTC may be stored.



PROCEDURE

1.REPLACE LANE DEPARTURE WARNING CAMERA
a.

Replace the lane departure warning camera with a new one (See page Engine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>REMOVAL).


b.

Perform the lane departure warning camera adjustment (See page Engine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT).



NEXT

END (LANE DEPARTURE WARNING CAMERA WAS DEFECTIVE)