Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › 2014.11–2015.08
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301643 LANE DEPARTURE ALERT SYSTEM C

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  C1AA4  Yaw Rate Sensor Circuit  C1AA5  Yaw Rate Sensor Power Supply Voltage Circuit  C1AA6  Yaw Rate Sensor Zero Point Malfunction  


DESCRIPTION

The brake booster with master cylinder assembly (skid control ECU) receives vehicle stability signals from the yaw rate sensor and sends the signals to the lane departure warning camera. If the brake booster with master cylinder assembly (skid control ECU) or yaw rate sensor detects that the yaw rate sensor is malfunctioning, the brake booster with master cylinder assembly (skid control ECU) or yaw rate sensor sends a malfunction signal to the lane departure warning camera and the lane departure warning camera stores DTC C1AA4, C1AA5 or C1AA6.

DTC No. DTC Detection Condition Trouble Area
C1AA4 While driving with the lane departure alert system activated, a yaw rate sensor malfunction signal sent from the yaw rate sensor to the lane departure warning camera is detected for 5 seconds or more.
·

Lane departure warning camera

·

Yaw rate sensor


C1AA5 While driving with the lane departure alert system activated, a yaw rate sensor power supply voltage malfunction signal sent from the yaw rate sensor to the lane departure warning camera is detected for 5 seconds or more.
·

Lane departure warning camera

·

Yaw rate sensor


C1AA6 While driving with the lane departure alert system activated, a yaw rate sensor zero point malfunction signal sent from the brake booster with master cylinder assembly (skid control ECU) to the lane departure warning camera is detected for 5 seconds or more.
·

Electronically controlled brake system

·

Lane departure warning camera



CAUTION / NOTICE / HINT

NOTICE:
·

When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera axis must be performed (See page Engine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT).

·

When replacing the lane departure warning camera, always replace it with a new one. If a lane departure warning camera which was installed to another vehicle is used, the information stored in the lane departure warning camera will not match the information from the vehicle. As a result, a DTC may be stored.



PROCEDURE

1.CHECK FOR DTCs (AIRBAG SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / SRS Airbag / Trouble Codes.



Result:
Result Proceed to
Airbag system DTCs are not output A
Airbag system DTCs are output B



A

2.CHECK FOR DTCs (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)

B

2.CHECK FOR DTCs (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.



Result:
Result Proceed to
Electronically controlled brake system DTCs are not output A
Electronically controlled brake system DTCs are output B



A

3.CHECK FOR DTCs (LANE DEPARTURE ALERT SYSTEM)

B

3.CHECK FOR DTCs (LANE DEPARTURE ALERT SYSTEM)

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.




Result:
Result Proceed to
DTC C1AA4, C1AA5 and C1AA6 are not output A
DTC C1AA4, C1AA5 or C1AA6 is output B



A

B