Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › 2014.11–2016.05
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301643 LANE DEPARTURE ALERT SYSTEM C

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  U1000  CAN Communication Failure (Message Registry)  


DESCRIPTION

The lane departure warning camera monitors its internal condition. When an internal malfunction is detected, the lane departure warning camera stores DTC U1000 and cancels lane departure alert system control.

DTC Code DTC Detection Condition Trouble Area
U1000 When the power switch is turned on (IG), a CAN communication malfunction is detected. Lane departure warning camera

CAUTION / NOTICE / HINT

NOTICE:
·

When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera axis must be performed (See page Engine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT).

·

When replacing the lane departure warning camera, always replace it with a new one. If a lane departure warning camera which was installed to another vehicle is used, the information stored in the lane departure warning camera will not match the information from the vehicle. As a result, a DTC may be stored.



PROCEDURE

1.CHECK FOR DTCs (HEALTH CHECK)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: System Select / Health Check.


e.

Check for DTCs.


Result
Result Proceed to
DTC U1000 only is output A
DTCs other than U1000 are output B


A

B