The lane departure warning camera monitors its internal condition. When an internal malfunction is detected, the lane departure warning camera stores DTC U1000 and cancels lane departure alert system control.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U1000 | When the power switch is turned on (IG), a CAN communication malfunction is detected. | Lane departure warning camera |
When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera axis must be performed (See page Engine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT).
When replacing the lane departure warning camera, always replace it with a new one. If a lane departure warning camera which was installed to another vehicle is used, the information stored in the lane departure warning camera will not match the information from the vehicle. As a result, a DTC may be stored.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: System Select / Health Check.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC U1000 only is output | A |
| DTCs other than U1000 are output | B |
A
B