1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
G3834
2.REMOVE SERVICE PLUG GRIP
51441
3.REMOVE NO. 1 ENGINE UNDER COVER
4.DRAIN COOLANT (for Engine)
5.DRAIN COOLANT (for Inverter)
53289A
6.REMOVE RADIATOR SUPPORT OPENING COVER
G9214
7.REMOVE NO. 1 INVERTER BRACKET
82111
8.DISCONNECT ENGINE ROOM MAIN WIRE
G9221
9.REMOVE INVERTER COVER
10.CHECK TERMINAL VOLTAGE
82164
11.DISCONNECT FRAME WIRE
G2148
12.DISCONNECT GENERATOR CABLE
G1148
13.DISCONNECT MOTOR CABLE
82122
14.DISCONNECT NO. 2 ENGINE WIRE
G9221
15.INSTALL INVERTER COVER
82112
16.DISCONNECT NO. 2 ENGINE ROOM WIRE
17.DISCONNECT WATER HOSE
G9200
18.REMOVE INVERTER WITH CONVERTER ASSEMBLY
G92A0A
19.REMOVE INVERTER RESERVE TANK ASSEMBLY
G9219A
20.REMOVE INVERTER TRAY BRACKET
16577C
21.REMOVE RADIATOR PIPE
Disconnect the 3 clamps, No. 1 radiator hose, No. 4 water by-pass hose and No. 3 radiator hose.
Remove the 2 bolts and radiator pipe from the hybrid vehicle transaxle assembly.
G2148
22.REMOVE GENERATOR CABLE
Wear insulated gloves.
Disconnect the generator cable clamp from the motor cable bracket.
Remove the 3 bolts and slide the generator cable connector shell back.
Disengage the 2 claws to remove the terminal cap.
Remove the 3 bolts and generator cable from the hybrid vehicle transaxle assembly.