Home › Drivetrain › P410 (HYBRID TRANSMISSION / TRANSAXLE) › HYBRID TRANSAXLE FLUID › from 2014.11
RM2070E _52 Drivetrain _061915 P410 HYBRID TRANSMISSION / TRANSAXLE _0301649 HYBRID TRANSAXLE FLUID A

P410 HYBRID TRANSMISSION / TRANSAXLE  HYBRID TRANSAXLE FLUID  REPLACEMENT  


PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 2.REPLACE HYBRID TRANSAXLE FLUID

a.

Be sure that the vehicle remains level and lift the vehicle. [*1]


b.
C210279E01
0.428,1.309 0.600,1.475 0.172,0.166 10 *1 0.647,1.729 0.818,1.895 0.172,0.166 10 *2 1.111,1.394 0.597,1.394 false 1.345,1.817 0.835,1.817 false

Using a 10 mm hexagon socket wrench, remove the filler plug and gasket. [*2]

Text in Illustration
*1 Filler Plug
*2 Drain Plug


c.

Using a 10 mm hexagon socket wrench, remove the drain plug and gasket. [*3]


d.

Using a 10 mm hexagon socket wrench, temporarily install the drain plug and gasket. [*4]

HINT:

Because the drain plug will be removed again, the gasket can be reused at this time.



e.
C233704E04
1.573,0.104 1.677,0.104 1.677,0.104 1.75,1.396 false 0.448,1.49 0.385,1.49 0.385,1.49 0.229,1.24 false 1.365,0.021 1.542,0.198 0.177,0.177 10 false *1 0.469,1.396 0.646,1.573 0.177,0.177 10 false *2

Add transaxle fluid until the fluid level is between 0 and 10 mm (0 to 0.394 in.) from the bottom lip of the filler plug opening. [*5]

Text in Illustration
*1 Filler Plug
*2 Filler Nozzle

NOTICE:
·

Use Toyota Genuine ATF WS.

·

Be sure to fully insert the filler nozzle into the filler plug opening.

·

Be sure to add fluid slowly. If fluid is added quickly, the fluid may hit internal parts and bounce back, resulting in fluid coming out of the filler plug opening.

·

Be sure to directly check that the transaxle fluid level is within the specified range.

·

Insufficient or excessive amounts of transaxle fluid may damage the hybrid transaxle.




f.

Using a 10 mm hexagon socket wrench, temporarily install the filler plug and gasket. [*6]

HINT:

Because the filler plug will be removed again, the gasket can be reused at this time.



g.

Lower the vehicle. [*7]


h.

Connect the GTS to the DLC3 and turn the power switch on (IG). [*8]


i.

Put the engine in inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE). [*9]


j.

Idle the engine for 30 seconds with the power switch on (READY). [*10]


k.

Turn the power switch off. [*11]


l.

Repeat steps [*1] to [*11].


m.

Repeat steps [*1] to [*3].


n.

Using a 10 mm hexagon socket wrench, install the drain plug and a new gasket.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


Hide 51441 5.INSTALL NO. 1 ENGINE UNDER COVER