Home › Drivetrain › P410 (HYBRID TRANSMISSION / TRANSAXLE) › SHIFT LEVER › 2012.03–2013.08
RM2070E _52 Drivetrain _061915 P410 HYBRID TRANSMISSION / TRANSAXLE _0301652 SHIFT LEVER A

P410 HYBRID TRANSMISSION / TRANSAXLE  SHIFT LEVER  INSTALLATION  


PROCEDURE

Hide 33560 1.INSTALL SHIFT LOCK CONTROL UNIT ASSEMBLY

a.

Connect the 3 connectors to shift lock control unit assembly.


b.

Install the shift lock control unit assembly with the 3 nuts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 2.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 58810J 3.INSTALL CONSOLE BOX ASSEMBLY

Hide 55431B 4.INSTALL UPPER INSTRUMENT PANEL FINISH PANEL

Hide 6.INSTALL SHIFT LEVER KNOB

a.

Using a die (M6 x P1.00 mm), clean the threads of the shift control unit assembly.


b.
C302778

Turn the shift lever knob in the direction of the arrow in the illustration to install it.


c.
C302779E01
0.573,0.098 0.861,0.293 0.288,0.195 10 *a

Using a vernier caliper, adjust the height of the shift lever knob.

Standard height:

11.74 mm (0.462 in.)


Text in Illustration
*a Measuring Point


d.

Remove the protective tape around the shift lock control unit assembly.


Hide 7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 13.INSPECT SHIFT LEVER

a.

Turn the power switch on (READY).


b.

Check that all available shift positions can be selected by moving the shift lever.

HINT:

After the shift lock control unit assembly is replaced with a new one, perform the above operation. If this operation is not performed, moving the shift lever may not initially select shift positions.