Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM › 2016.05–2017.12
RM2070E _54 Brake _061923 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0301683 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C1203/95  ECM Communication Circuit Malfunction  


DESCRIPTION

The circuit is used to send TRC and VSC information from the skid control ECU to the hybrid vehicle control ECU, and hybrid control system information from the hybrid vehicle control ECU to the skid control ECU via the CAN communication system.

Identification information sent from other ECUs is stored when shipped from the factory and used as default values.

NOTICE:

DTC C1203/95 is output when an incorrect ECU is installed. If initialization is performed and learning occurs with an incorrect ECU installed, operations and functions will differ from that stored when the vehicle was shipped from the factory. Therefore, make sure that learning occurs properly.


DTC Code INF Code DTC Detection Condition Trouble Area
C1203/95 - Either of the following is detected:
1.

Identification information sent from other ECUs does not match with the value stored when shipped from the factory.

2.

No stored information for destination.


·

The wrong ECU or sensor was installed

·

Brake booster with master cylinder (Skid control ECU)



CAUTION / NOTICE / HINT

NOTICE:

When replacing the brake booster with master cylinder (skid control ECU), perform initialization and calibration of the linear solenoid valve (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION).


PROCEDURE

1.CHECK PART NUMBER
a.

Check that a proper hybrid vehicle control ECU, main body ECU and yaw rate and acceleration sensor (airbag ECU assembly) are installed.

OK:

Proper ECUs and sensor are installed.



b.

Check if the hybrid vehicle control ECU, main body ECU and yaw rate and acceleration sensor (airbag ECU assembly) had been replaced before the DTC was recorded.

OK:

ECU or sensor had not been replaced.


Result:
Result Proceed to
OK A
NG (A proper hybrid vehicle control ECU is not installed and/or the hybrid vehicle control ECU had been replaced) B
NG (A proper main body ECU is not installed and/or the main body ECU had been replaced) C
NG (A proper yaw rate and acceleration sensor (airbag ECU assembly) is not installed and/or the yaw rate and acceleration sensor (airbag ECU assembly) had been replaced) D




A

2.PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE

B

C

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

D

2.PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE
a.

Perform initialization and calibration of the linear solenoid valve (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION).

HINT:

Before performing initialization and calibration of the linear solenoid valve, C1203/95 will be output.




NEXT

3.RECONFIRM DTC
3.RECONFIRM DTC
a.

Turn the power switch off (lock).



c.

Turn the power switch on (IG).


d.

Check if the same DTC is recorded (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC (C1203/95) is output (for LHD) A
DTC (C1203/95) is output (for RHD) B
DTC (C1203/95) is not output C




A

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER

B

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER

C

END