Home › Brake › PARKING BRAKE › PARKING BRAKE PEDAL (for LHD) › from 2016.05
RM2070E _54 Brake _061927 PARKING BRAKE _0301706 PARKING BRAKE PEDAL(for LHD) A

PARKING BRAKE  PARKING BRAKE PEDAL(for LHD)  INSTALLATION  


PROCEDURE

Hide 46200 1.INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

a.
C237802

Install the parking brake control pedal assembly with the bolt and 2 nuts.

Torque:
15 N*m (148 kgf*cm, 11 ft.*lbf)


b.
C237801

Connect the parking brake switch connector.


c.

Engage the wire harness clamp.


d.
C237812

Install the No. 1 parking brake cable assembly with the 4 bolts and nut.

Torque:
15 N*m (148 kgf*cm, 11 ft.*lbf)


e.

Install the No. 1 parking brake cable assembly to the clamp.


f.

Engage the 2 wire harness clamps.


g.
C237800E03
0.719,1 0.375,1 false 0.906,1.031 0.906,1.333 false 0.208,0.927 0.385,1.115 0.177,0.188 10 true *1 0.823,1.333 1,1.51 0.177,0.177 10 true *2

Temporarily install the lock nut.

Text in Illustration
*1 Lock Nut
*2 Adjusting Nut

HINT:

After adjusting parking brake pedal travel, tighten the lock nut.



Hide 46302 2.CONNECT NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY

a.
C236289E02
0.906,0.375 1.073,0.521 0.167,0.146 10 false *a 2.021,0.635 2.188,0.781 0.167,0.146 10 false *b

Connect the No. 1 parking brake pull rod sub-assembly to the parking brake control pedal assembly as shown in the illustration.

Text in Illustration
*a Turn
*b Hold

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 3.INSTALL AIR CONDITIONING UNIT ASSEMBLY

Hide 5.ADJUST PARKING BRAKE PEDAL TRAVEL