Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM2070E _55 Steering _061928 POWER ASSIST SYSTEMS _0301712 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1515/15  Torque Sensor Zero Point Adjustment is not Initialized  C1525/17  Rotation Angle Sensor Initialization Undone  


DESCRIPTION

These DTCs do not indicate a malfunction. The power steering ECU assembly stores these DTCs when it determines that rotation angle sensor value initialization and torque sensor zero point calibration have not been performed.

DTC No. DTC Detection Condition Trouble Area
C1515/15 This DTC is stored when torque sensor zero point calibration has not been performed. There is no malfunction if this DTC is not output again after performing zero point calibration.
C1525/17 This DTC is stored when rotation angle sensor value initialization has not been performed. There is no malfunction if this DTC is not output again after performing rotation angle sensor value initialization.

CAUTION / NOTICE / HINT

NOTICE:
·

If the power steering ECU assembly has been replaced with a new one, perform assist map writing and rotation angle sensor value initialization torque sensor zero point calibration after performing the initialization of the torque sensor zero point value (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).

·

If the steering column assembly has been replaced with a new one, perform rotation angle sensor value initialization torque sensor zero point calibration after performing the initialization of the torque sensor zero point value (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).



PROCEDURE

1.CHECK FOR DTC
a.

Initialize the rotation angle sensor value and calibrate the torque sensor zero point (step 1) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).



HINT:

If DTCs are output, perform steps 1 and 2 two more times.


Result:
Result Proceed to
DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 3 times. A
Normal system code is output. B



A

2.REPLACE POWER STEERING ECU ASSEMBLY

B

END

2.REPLACE POWER STEERING ECU ASSEMBLY
a.

Replace the power steering ECU assembly (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING ECU>REMOVAL).



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC
a.

Initialize the rotation angle sensor value and calibrate the torque sensor zero point (step 1) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).



HINT:

If DTCs are output, perform steps 1 and 2 two more times.


Result:
Result Proceed to
DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 3 times. A
Normal system code is output. B



A

REPLACE STEERING COLUMN ASSEMBLY

B

END