Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM2070E _55 Steering _061928 POWER ASSIST SYSTEMS _0301712 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1516/16  Torque Sensor Zero Point Adjustment Incomplete  C1526/18  Rotation Angle Sensor Initialization Incomplete  


DESCRIPTION

These DTCs do not indicate a malfunction. The power steering ECU assembly outputs these DTCs when it determines that rotation angle sensor value initialization and torque sensor zero point calibration are incomplete.

DTC No. DTC Detection Condition Trouble Area
C1516/16 Torque sensor zero point calibration is incomplete due to the steering wheel being touched during calibration. There is no malfunction if this DTC is not output again after clearing the DTCs and torque sensor calibration value, and performing zero point calibration.
C1526/18 Rotation angle sensor value initialization is incomplete due to the steering wheel being touched during calibration. There is no malfunction if this DTC is not output again after clearing the DTCs and torque sensor calibration value, and performing rotation angle sensor value initialization.

CAUTION / NOTICE / HINT

NOTICE:
·

If the power steering ECU assembly has been replaced with a new one, perform assist map writing and rotation angle sensor value initialization torque sensor zero point calibration after performing the initialization of the torque sensor zero point value (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).

·

If the steering column assembly has been replaced with a new one, perform rotation angle sensor value initialization torque sensor zero point calibration after performing the initialization of the torque sensor zero point value (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).



PROCEDURE

1.CHECK FOR DTC

b.

Initialize the rotation angle sensor value and calibrate the torque sensor zero point (step 2) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


c.

Check for DTCs (step 3) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

HINT:

If DTCs are output, perform steps 1 to 3 two more times.


Result:
Result Proceed to
DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 3 times. A
Normal system code is output. B




A

2.REPLACE POWER STEERING ECU ASSEMBLY

B

END

2.REPLACE POWER STEERING ECU ASSEMBLY
a.

Replace the power steering ECU assembly (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING ECU>REMOVAL).



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC

b.

Initialize the rotation angle sensor value and calibrate the torque sensor zero point (step 2) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


c.

Check for DTCs (step 3) (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

HINT:

If DTCs are output, perform steps 1 to 3 two more times.


Result:
Result Proceed to
DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 3 times. A
Normal system code is output. B




A

REPLACE STEERING COLUMN ASSEMBLY

B

END