The power steering ECU assembly stores this DTC when it determines that the assist map is not written in the ECU.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1581/26 | Assist map not written in power steering ECU assembly | ·
Power steering ECU assembly ·
CAN communication system ·
Hybrid control system |
If the power steering ECU assembly has been replaced with a new one, perform assist map writing and rotation angle sensor value initialization torque sensor zero point calibration after performing the initialization of the torque sensor zero point value (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
Perform assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
NEXT
Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
DTC is not output.
OK
NG
Check for DTCs (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>DIAGNOSIS SYSTEM for with Central Gateway ECU or Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>DIAGNOSIS SYSTEM for without Central Gateway ECU).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output (w/ Central Gateway ECU) | B |
| DTC is output (w/o Central Gateway ECU) | C |
If a CAN communication system DTC is output, first troubleshoot the CAN communication system malfunction, then perform assist map writing again (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
A
B
C
Check for DTCs (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DTC CHECK / CLEAR).
DTC is not output.
If a hybrid control system DTC is output, first troubleshoot the hybrid control system, then perform assist map writing again (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
OK
NG