45047
1.INSTALL TIE ROD END SUB-ASSEMBLY LH
Install the lock nut and tie rod end sub-assembly LH to the steering gear assembly until the matchmarks are aligned.
| *a | Matchmark |
After adjusting the toe-in, tighten the lock nut.
45046
2.INSTALL TIE ROD END SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.
3.INSTALL STEERING LINK ASSEMBLY
Install the steering link assembly to the front suspension crossmember sub-assembly with the 2 bolts and 2 nuts.
Keep the nut from rotating while turning the bolt because the nut has its own stopper.
Make sure to tighten the bolts starting from the left side of the vehicle.
45221
4.INSTALL STEERING INTERMEDIATE SHAFT
Align the matchmarks and install the steering intermediate shaft to the steering link assembly.
| *a | Matchmark |
Install the bolt.
45025D
5.INSTALL NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
Align the round hole in the No. 1 steering column hole cover sub-assembly with the protrusion of the steering link assembly to install the cover.
51201
6.INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
52258A
7.INSTALL FRONT SUSPENSION MEMBER REAR BRACE LH
52257
8.INSTALL FRONT SUSPENSION MEMBER REAR BRACE RH
Perform the same procedure as for the LH side.
51108A
9.INSTALL REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY LH
51107A
10.INSTALL REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.
51425A
11.INSTALL FRONT ENGINE MOUNTING BRACKET LOWER REINFORCEMENT
48069
12.CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
48068
13.CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.
45047
14.CONNECT TIE ROD END SUB-ASSEMBLY LH
Connect the tie rod end sub-assembly LH to the steering knuckle with the nut.
Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.
Install a new cotter pin.
45046
15.CONNECT TIE ROD END SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.
48810
16.INSTALL FRONT STABILIZER LINK ASSEMBLY LH
48820B
17.INSTALL FRONT STABILIZER LINK ASSEMBLY RH
Perform the same procedure as for the LH side.
45025D
18.CONNECT NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
Place clip A as shown in the illustration and engage clip B to the body to connect the No. 1 steering column hole cover sub-assembly.
| *1 | Clip A |
| *2 | Clip B |
| *a | Lip |
Make sure that the lip of the No. 1 steering column hole cover sub-assembly is not damaged.
45260
19.CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY
45259A
20.INSTALL COLUMN HOLE COVER SILENCER SHEET
51444A
21.INSTALL REAR ENGINE UNDER COVER LH
51443C
22.INSTALL REAR ENGINE UNDER COVER RH
51442A
23.INSTALL FRONT NO. 3 ENGINE UNDER COVER
51442E
24.INSTALL NO. 2 ENGINE UNDER COVER
51441
25.INSTALL NO. 1 ENGINE UNDER COVER
26.INSTALL FRONT WHEELS
27. STABILIZE SUSPENSION
28.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT