Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2014.11–2020.08
RM2070E _56 Audio / Visual / Telematics _061931 AUDIO / VIDEO _0301730 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Touch Panel Switch does not Function  


PROCEDURE

1.CHECK MULTI-DISPLAY
a.

Check if there is any foreign matter caught between the display and exterior frame of the multi-display.

OK:

No foreign matter is caught between the display and exterior frame of the multi-display.


HINT:

If there is foreign matter between the display and exterior frame of the multi-display, the touch panel will remain pressed, preventing touch switch operation.




OK

2.CHECK TOUCH PANEL

NG

REMOVE FOREIGN MATTER

2.CHECK TOUCH PANEL
a.

Check for foreign matter on the display.

OK:

The display is clean.




OK

3.CHECK TOUCH SWITCH (OPERATION CHECK)

NG

CLEAN DISPLAY AND RECHECK TOUCH PANEL

3.CHECK TOUCH SWITCH (OPERATION CHECK)
E176521

a.

Enter the "Touch Switch Check" screen. Refer to Check Touch Switch in Operation Check (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>OPERATION CHECK).


b.

Touch the display in the area where the switch malfunction occurs.

OK:

A "+" mark appears at the touched position.




OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE