1. PRECAUTION
When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.
86804A
2.INSTALL NAVIGATION ECU SUB-ASSEMBLY
86271L
3.INSTALL HARD DISK DRIVE
86211J
4.INSTALL NO. 1 RADIO RECEIVER BRACKET
Install the No. 1 radio receiver bracket with the 4 screws.
86212C
5.INSTALL NO. 2 RADIO RECEIVER BRACKET
Use the same procedure as for the No. 1 radio receiver bracket.
6.INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET
Connect each connector.
Engage the 2 guides and 5 claws.
Install the navigation receiver assembly with bracket with the 4 bolts.
7.INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY
55440D
8.INSTALL INSTRUMENT PANEL BOX ASSEMBLY
9.INSTALL INTEGRATION CONTROL AND PANEL
10.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
64995
11.INSTALL DECK FLOOR BOX RH
64993
12.INSTALL REAR DECK FLOOR BOX
58411A
13.INSTALL NO. 1 DECK BOARD
58412A
14.INSTALL NO. 2 DECK BOARD
58410B
15.INSTALL DECK BOARD ASSEMBLY
16.INSPECT HARD DISK DRIVE
17.REPLACED OPERATION