Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › HARD DISK DRIVE › 2012.03–2013.08
RM2070E _56 Audio / Visual / Telematics _061932 NAVIGATION / MULTI INFO DISPLAY _0301735 HARD DISK DRIVE A

NAVIGATION / MULTI INFO DISPLAY  HARD DISK DRIVE  INSTALLATION  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

When installing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.


Hide 86271L 2.INSTALL HARD DISK DRIVE

a.
E229268

Insert the hard disk drive in the direction shown by the arrow in the illustration to install it.

NOTICE:

To reduce the chance of bending the pins, make sure to keep the hard disk drive straight when inserting it.



b.

Engage the 2 guides to temporarily install the cover.


c.

Install the cover with the 2 screws.


Hide 86212C 3.INSTALL NO. 2 RADIO RECEIVER BRACKET

HINT:

Use the same procedure as for the No. 1 receiver radio bracket (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION RECEIVER>INSTALLATION).


Hide 5.INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 8.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).