Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER › 2013.08–2014.11
RM2070E _56 Audio / Visual / Telematics _061932 NAVIGATION / MULTI INFO DISPLAY _0301734 NAVIGATION RECEIVER A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER  INSTALLATION  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.


Hide 86804A 2.INSTALL NAVIGATION ECU SUB-ASSEMBLY

Hide 86211J 4.INSTALL NO. 1 RADIO RECEIVER BRACKET

a.

Install the No. 1 radio receiver bracket with the 4 screws.


Hide 86212C 5.INSTALL NO. 2 RADIO RECEIVER BRACKET

HINT:

Use the same procedure as for the No. 1 radio receiver bracket.


Hide 6.INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET

a.

Connect each connector.


b.

Engage the 2 guides and 5 claws.


c.

Install the navigation receiver assembly with bracket with the 4 bolts.


Hide 7.INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 10.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).