1. PRECAUTION
When installing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.
86271L
2.INSTALL HARD DISK DRIVE
Insert the hard disk drive in the direction shown by the arrow in the illustration to install it.
To reduce the chance of bending the pins, make sure to keep the hard disk drive straight when inserting it.
Engage the 2 guides to temporarily install the cover.
Install the cover with the 2 screws.
86212C
3.INSTALL NO. 2 RADIO RECEIVER BRACKET
Use the same procedure as for the No. 1 receiver radio bracket (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION RECEIVER>INSTALLATION).
4.INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET
5.INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY
55440D
6.INSTALL INSTRUMENT PANEL BOX ASSEMBLY
7.INSTALL INTEGRATION CONTROL AND PANEL
8.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
64995
9.INSTALL DECK FLOOR BOX RH
64993
10.INSTALL REAR DECK FLOOR BOX
58411A
11.INSTALL NO. 1 DECK BOARD
58412A
12.INSTALL NO. 2 DECK BOARD
58410B
13.INSTALL DECK BOARD ASSEMBLY
14.INSPECT HARD DISK DRIVE