Check the radio automatic station search function.
Check the radio automatic station search function by activating it.
| Result | Proceed to |
|---|---|
| Automatic station search function does not stop. | A |
| Automatic station search function stops on a station. | B |
A
B
Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.
| Result | Proceed to |
|---|---|
| Optional components are not installed. | A |
| Optional components are installed. | B |
Do not remove optional components without the permission of the customer.
A
B
Preparation for check
Remove the antenna connector from the radio and display receiver assembly.
Check for noise
Turn the power switch on (ACC) with the radio and display receiver assembly connector connected.
Turn the radio on and tune into AM mode.
Place a screwdriver, thin wire or other metal object on the radio and display receiver assembly antenna jack and check that noise can be heard from the speakers.
Noise can be heard from the speakers.
OK
NG
Disconnect the RA radio and display receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| RA-5 (ANT+) - Body ground | Power switch on (ACC)
Radio switch on and AM or FM selected |
11 to 14 V |
| *a | Component without harness connected
(Radio and Display Receiver Assembly) |
OK
NG
Replace the antenna cord sub-assembly with a new or known good one and check if radio broadcasts can be received normally (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD>REMOVAL).
Radio broadcasts can be received normally.
OK
NG
Replace the No. 2 antenna cord sub-assembly with a new or known good one and check if radio broadcasts can be received normally (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD>REMOVAL).
Radio broadcasts can be received normally.
OK
NG
Replace the No. 1 amplifier antenna assembly with a new or known good one and check if radio broadcasts can be received normally (See page Audio / Visual / Telematics>AUDIO / VIDEO>AMPLIFIER ANTENNA(for Roof)>REMOVAL).
Radio broadcasts can be received normally.
OK
NG
Replace the roof antenna pole sub-assembly with a new or known good one and check if radio broadcasts can be received normally (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA POLE>REMOVAL).
Radio broadcasts can be received normally.
OK
NG