These DTCs are stored when a malfunction occurs in the No. 1 amplifier antenna assembly.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15C0 | Navigation antenna malfunction | ·
No. 1 amplifier antenna assembly ·
Antenna cord sub-assembly ·
No. 2 antenna cord sub-assembly ·
Navigation ECU |
| B15C1 | Navigation antenna power source malfunction |
Check that the No. 1 amplifier antenna assembly cable, antenna cord sub-assembly and No. 2 antenna cord sub-assembly are properly installed and does not have any sharp bends, pinching or loose connections before performing the following inspection procedure (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>ELECTRONIC CIRCUIT INSPECTION PROCEDURE).
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Replace the antenna cord sub-assembly with a new or known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD>REMOVAL).
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
OK
NG
Replace the No. 2 antenna cord sub-assembly with a new or known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD>REMOVAL).
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
OK
NG
Replace the No. 1 amplifier antenna assembly with a new or known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>AMPLIFIER ANTENNA(for Roof)>REMOVAL).
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
OK
NG