Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type) › 2016.05–2020.08
RM2070E _56 Audio / Visual / Telematics _061932 NAVIGATION / MULTI INFO DISPLAY _0301739 NAVIGATION SYSTEM(for Radio and Display Type) C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  B15C0  Short in GPS Antenna  B15C1  Open in GPS Antenna  


DESCRIPTION

These DTCs are stored when a malfunction occurs in the No. 1 amplifier antenna assembly.

DTC No. DTC Detection Condition Trouble Area
B15C0 Navigation antenna malfunction
·

No. 1 amplifier antenna assembly

·

Antenna cord sub-assembly

·

No. 2 antenna cord sub-assembly

·

Navigation ECU


B15C1 Navigation antenna power source malfunction

CAUTION / NOTICE / HINT

NOTICE:

Check that the No. 1 amplifier antenna assembly cable, antenna cord sub-assembly and No. 2 antenna cord sub-assembly are properly installed and does not have any sharp bends, pinching or loose connections before performing the following inspection procedure (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>ELECTRONIC CIRCUIT INSPECTION PROCEDURE).


PROCEDURE

1.CHECK DTC

b.

Recheck for DTCs and check that no DTCs are output.

OK:

No DTCs are output.




OK

NG

2.REPLACE ANTENNA CORD SUB-ASSEMBLY
2.REPLACE ANTENNA CORD SUB-ASSEMBLY
a.

Replace the antenna cord sub-assembly with a new or known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD>REMOVAL).



c.

Recheck for DTCs and check that no DTCs are output.

OK:

No DTCs are output.




OK

END

NG

3.REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY
3.REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY
a.

Replace the No. 2 antenna cord sub-assembly with a new or known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD>REMOVAL).



c.

Recheck for DTCs and check that no DTCs are output.

OK:

No DTCs are output.




OK

END

NG

4.REPLACE NO. 1 AMPLIFIER ANTENNA ASSEMBLY
4.REPLACE NO. 1 AMPLIFIER ANTENNA ASSEMBLY
a.

Replace the No. 1 amplifier antenna assembly with a new or known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>AMPLIFIER ANTENNA(for Roof)>REMOVAL).



c.

Recheck for DTCs and check that no DTCs are output.

OK:

No DTCs are output.




OK

END

NG