This DTC is stored when the parking assist ECU judges that the back camera initial setting has not been memorized (rear television camera optical axis adjustment is incomplete).
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1691 | Back camera initial setting has not been memorized | ·
Height control sensor vehicle height difference setting ·
Rear television camera optical axis adjustment ·
Parking assist ECU |
When the "System initializing" message is displayed on the radio and display receiver assembly*1 or navigation receiver assembly*2 after the auxiliary battery cable has been disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>INITIALIZATION).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).
*1: for Radio and Display Type
*2: for Navigation Receiver Type
Perform the following procedure depending on the memory conditions to register the vehicle information into the parking assist ECU.
Before performing the rear television camera optical axis adjustment, the height control sensor vehicle height difference setting must be performed in the "HEIGHT SET" screen.
Height control sensor vehicle height difference setting (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION)
Rear television camera optical axis adjustment (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION)
NEXT
Clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1691 is output | A |
| DTCs are not output | B |
If DTC C1691 is output, perform rear television camera optical axis adjustment again.
If DTC C1691 is still output after performing height control sensor vehicle height difference setting and rear television camera optical axis adjustment 3 times, replace the parking assist ECU.
A
B