Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM › 2014.11–2020.08
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301741 INTELLIGENT PARKING ASSIST SYSTEM C

PARK ASSIST / MONITORING  INTELLIGENT PARKING ASSIST SYSTEM  C1695  Zero point Calibration of Vehicle Height Sensor Incomplete  


DESCRIPTION

This DTC is stored when the parking assist ECU judges that the zero point calibration of the vehicle height sensor is incomplete (height control sensor vehicle height difference setting is incomplete).

DTC No. DTC Detection Condition Trouble Area
C1695 Zero point calibration of vehicle height sensor is incomplete
·

Height control sensor vehicle height difference setting

·

Parking assist ECU



CAUTION / NOTICE / HINT

NOTICE:
·

When the "System initializing" message is displayed on the radio and display receiver assembly*1 or navigation receiver assembly*2 after the auxiliary battery cable has been disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).


*1: for Radio and Display Type

*2: for Navigation Receiver Type



PROCEDURE

1.ADJUST SETTINGS (HEIGHT CONTROL SENSOR VEHICLE HEIGHT DIFFERENCE SETTING)
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the parking assist ECU.

i.

Height control sensor vehicle height difference setting (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION)




NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT

b.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC C1695 is output A
DTCs are not output B


HINT:
·

If DTC C1695 is output, perform height control sensor vehicle height difference setting again.

·

If DTC C1695 is still output after performing height control sensor vehicle height difference setting 3 times, replace the parking assist ECU.





A

B

END