The rear television camera assembly can create parking guide lines. Because this function is not necessary on vehicles with the intelligent parking assist system, the guide line creation function of the rear television camera assembly is disabled.
When "System initializing" is displayed on the multi-display after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>INITIALIZATION).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).
Check the intelligent parking assist screen.
| Result | Proceed to |
|---|---|
| Guide lines are displayed with vehicle center lines | A |
| Guide lines are displayed without vehicle center lines | B |
| *a | Vehicle Center Line |
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
Disconnect the V14 rear television camera assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| V14-1 (CURT) - Body ground | Always | Below 1 Ω |
OK
NG