Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM › 2015.08–2016.05
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301741 INTELLIGENT PARKING ASSIST SYSTEM J

PARK ASSIST / MONITORING  INTELLIGENT PARKING ASSIST SYSTEM  Guide Lines are Displayed with Vehicle Center Line  


DESCRIPTION

The rear television camera assembly can create parking guide lines. Because this function is not necessary on vehicles with the intelligent parking assist system, the guide line creation function of the rear television camera assembly is disabled.

WIRING DIAGRAM

E224386E38
3.313,1.073 5.51,1.323 2.198,0.25 10 false Rear Television Camera Assembly 2.625,0.292 2.802,0.479 0.177,0.188 10 false 1 2.813,0.406 3.313,0.594 0.5,0.188 10 false CURT 3.313,0.906 3.813,1.094 0.5,0.188 10 false V14

CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the multi-display after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).



PROCEDURE

1.CHECK SCREEN MODE
a.
E307216E01
2.285,0.384 2.542,0.651 0.258,0.267 10 *a 1.763,1.621 2.302,0.579 false

Check the intelligent parking assist screen.

Result:
Result Proceed to
Guide lines are displayed with vehicle center lines A
Guide lines are displayed without vehicle center lines B


Text in Illustration
*a Vehicle Center Line



A

2.CHECK HARNESS AND CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY - BODY GROUND)

B

2.CHECK HARNESS AND CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY - BODY GROUND)
a.

Disconnect the V14 rear television camera assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
V14-1 (CURT) - Body ground Always Below 1 Ω




OK

REPLACE REAR TELEVISION CAMERA ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR