86792C
1.INSTALL PARKING ASSIST ECU
Engage the claw to install the parking assist ECU.
If the driving support ECU assembly was removed, install it after installing the parking assist ECU (See page Engine / Hybrid System>CRUISE CONTROL>DRIVING SUPPORT ECU>INSTALLATION).
82877
2.INSTALL ECU INTEGRATION BOX RH (for LHD)
82877
3.INSTALL ECU INTEGRATION BOX RH (for RHD)
Install the ECU integration box RH with the nut and bolt.
Connect each connector.
55550
4.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD)
55607
5.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)
55480D
6.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for RHD)
7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
64995
8.INSTALL DECK FLOOR BOX RH
64993
9.INSTALL REAR DECK FLOOR BOX
58411A
10.INSTALL NO. 1 DECK BOARD
58412A
11.INSTALL NO. 2 DECK BOARD
58410B
12.INSTALL DECK BOARD ASSEMBLY