Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Start Function) › 2013.08–2014.11
RM2070E _58 Vehicle Interior _061938 THEFT DETERRENT / KEYLESS ENTRY _0301768 ENTRY AND START SYSTEM(for Start Function) C

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM(for Start Function)  B2277  Detecting Vehicle Submersion  


DESCRIPTION

This DTC is stored when a malfunction in the water submersion detection circuit in the power management control ECU is detected.

HINT:
·

When the power management control ECU is replaced with a new one and the cable is connected to the negative (-) auxiliary battery terminal, the power source mode changes to on (IG).

·

When the auxiliary battery cable is disconnected and reconnected, the power source returns to the mode it was in before the auxiliary battery cable was disconnected.



DTC Code DTC Detection Condition Trouble Area DTC Output Confirmation Operation
B2277 The water submersion detection circuit in the power management control ECU detects water submersion (1-trip detection logic*).
·

Submersion of power management control ECU in water

·

Power management control ECU


Wait 300 seconds after connecting the auxiliary battery cable.

*: Only output while a malfunction is present and the power switch is on (IG)


Vehicle Condition and Fail-safe Function when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Function when Malfunction Detected
The hybrid control system cannot be turned off and the hybrid control system cannot be started. The power source mode changes to on (IG) and hybrid control system activation is prohibited.

CAUTION / NOTICE / HINT

NOTICE:
·

When using the GTS with the power switch off, perform either of the following: 1) Turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and vehicle begins, or 2) connect the GTS to the vehicle, select the vehicle type under manual mode, and then enter the following menus:

for Power Source Control: Body Electrical / Power Source Control / Trouble Codes.

for Entry&Start: Body Electrical / Entry&Start / Trouble Codes.

·

The entry and start system uses multiplex communication. First perform the inspections in "How to Proceed with Troubleshooting" to confirm that there are no communication malfunctions before proceeding with troubleshooting (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Start Function)>HOW TO PROCEED WITH TROUBLESHOOTING).

·

After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.



HINT:
Related Data List and Active Test Items
DTC Data List Item Active Test Item
B2277 - -


HINT:

Before proceeding with troubleshooting, check if there are any signs of water damage to the power management control ECU. If there are any signs of water damage, replace the power management control ECU and take measures against the cause of the water damage.


PROCEDURE

1.CHECK FOR DTC

b.

Turn the power switch on (IG).


c.

After 330 seconds have elapsed, check if the DTC has been set again.

OK:

DTC B2277 is not output



HINT:

If there are any signs that water was present, before replacing the power management control ECU, take measures to prevent any further water entry.



OK

NG