Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM › 2012.03–2020.08
RM2070E _58 Vehicle Interior _061938 THEFT DETERRENT / KEYLESS ENTRY _0301770 THEFT DETERRENT SYSTEM C

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  B2764  Short to GND in Intrusion Sensor Signal Circuit  


DESCRIPTION

The intrusion sensor (theft warning ultrasonic sensor) (map light assembly) conducts self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).

If a malfunction is detected in the ISIF line, the main body ECU (multiplex network body ECU) stores this DTC.


DTC No. DTC Detection Condition Trouble Area
B2764 After normal/trouble signal is output from intrusion sensor as result of self-diagnosis, following malfunctions are detected:
1.

ISIF line circuit is shorted to ground

2.

Reception of signals other than normal/trouble signal


·

Intrusion sensor (theft warning ultrasonic sensor) (map light assembly)

·

Main body ECU (multiplex network body ECU)

·

Wire harness or connector



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MAP LIGHT ASSEMBLY - MAIN BODY ECU)
a.

Disconnect the L8 main body ECU (multiplex network body ECU) connector.


b.

Disconnect the U3 map light assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L8-12 (ISIF) - Body ground Always 10 kΩ or higher




OK

2.REPLACE INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (MAP LIGHT ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.REPLACE INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (MAP LIGHT ASSEMBLY)
a.

Replace intrusion sensor (theft warning ultrasonic sensor) (map light assembly) (See page Vehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL).



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC

b.

Turn the power switch on (IG), then off.


c.

Set the theft deterrent system to "ARMED STATE".


d.

Check that the security indicator changes from illuminated to blinking.


e.

Set the theft deterrent system to "DISARMED STATE".


f.


OK

END (INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (MAP LIGHT ASSEMBLY) WAS DEFECTIVE)

NG

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)