The main body ECU (multiplex network body ECU) controls the operation of the following lights:
Map light assembly
No. 1 room light assembly
Inspect fuses for circuits related to this system before performing the following inspection procedure.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Check that the lights operate.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Illuminated Entry System | Personal light and No. 1 room light assembly | ON/OFF | Interior light door switch on and all doors closed |
Each light fades in.
OK
NG
Disconnect the U3 map light assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U3-11 (+B1) - Body ground | Always | 11 to 14 V |
OK
NG
Remove the map light assembly (See page Vehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL).
Inspect the map light assembly (See page Vehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>INSPECTION).
Map light assembly is normal.
OK
NG
Disconnect the 2A instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U3-6 (CTY) - 2A-52*1 | Always | Below 1 Ω |
| U3-6 (CTY) - Body ground*1 | Always | 10 kΩ or higher |
| U3-16 (CTY) - 2A-52*2 | Always | Below 1 Ω |
| U3-16 (CTY) - Body ground*2 | Always | 10 kΩ or higher |
*1: for LHD
*2: for RHD
OK
NG
Remove the instrument panel junction block assembly (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2A-52 - MB-1 (ILE) | Always | Below 1 Ω |
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
OK
NG