Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
62180A
1.INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
Do not damage the roof headlining assembly.
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Engage the 10 hooks to temporarily install the curtain shield airbag assembly.
When installing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.
Do not twist the curtain shield airbag assembly when installing it.
Install 10 new bolts in the order shown in the illustration.
Connect the curtain shield airbag connector.
| *1 | Airbag Connector |
| *2 | Airbag Connector Lock |
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the airbag connector lock.
2.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.INSTALL ROOF HEADLINING ASSEMBLY
4. PERFORM DIAGNOSTIC SYSTEM CHECK
5.INSPECT SRS WARNING LIGHT