Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY › from 2014.11
RM2070E _58 Vehicle Interior _061942 SUPPLEMENTAL RESTRAINT SYSTEMS _0301804 FRONT SEAT SIDE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 73920A 1.INSTALL FRONT SEAT AIRBAG ASSEMBLY

CAUTION:
·

The nuts must not be reused.

·

Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.



a.

Install the front seat airbag assembly with 2 new nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


b.

Engage the 2 clamps.


Hide 2.INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Manual Seat)

Hide 3.INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat)

Hide 73920A 4.CONNECT FRONT SEAT AIRBAG ASSEMBLY

a.

w/ Seat Heater System:

i.

Engage the clamp to connect the seat heater wire harness.



b.

Engage the fastener to install the airbag wire harness.


c.
B282166

Engage the claw and 4 clamps to connect the airbag wire harness.


d.

Connect the rubber band.